Servo drive TG9 9g / 1.5kg / 0.10sec

The Turnigy TG9e is renowned as one of the most budget-friendly 9g micro servos in the world, offering a cost-effective alternative to the famous HXT900. Delivering an impressive transit speed of 0.10s and up to 1.5 kg/cm of torque, it is optimized for lightweight park flyers, indoor foamies, and budget-conscious RC projects where low weight and high value are critical.

Features

* **World-Class Budget Value:** Costs a fraction of premium alternatives while maintaining reliable tracking parameters for light-duty setups.

* **High-Speed Responsiveness:** Quick 0.10s response time provides agile and predictable handling inputs.

* **Extended 260mm Lead:** Generous pre-installed cable length simplifies routing through long wings and narrow fuselages.

* **Narrow 7µs Deadband:** Delivers crisp, tight response to PWM adjustments, minimizing slop.

Specifications

* **Brand:** Turnigy

* **Model:** TG9e Eco Micro Analog Servo

* **Dimensions:** 23.0 mm × 12.2 mm × 29.0 mm

* **Detailed Dimensions:** A: 29mm / B: 23mm / C: 27mm / D: 12.2mm / E: 33mm / F: 16mm

* **Net Weight:** 9.0 g

* **Deadband Width:** 7 µs

* **Operating Temperature:** 0°C to 55°C

* **Stall Torque:** 1.5 kg/cm (@ 4.8V)

* **Speed:** 0.10 sec / 60° (@ 4.8V) / 0.09 sec / 60° (@ 6.0V)

* **Voltage Range:** DC 4.8V – 6.0V

Operational Instructions

1. **Mounting:** Fit the servo into its mounting slot. Secure it with standard mounting screws without warping the plastic casing.

2. **Centering:** Power the system and apply a neutral signal (1500µs) to center the spline shaft before installing your control horn.

3. **Wiring:** Plug the 3-pin universal connector block directly into your receiver or flight controller PWM rail (Brown/Black: GND, Red: VCC, Orange/Yellow: Signal).

4. **Pre-Flight Check:** Manually verify that all connected linkages and pushrods move cleanly across their full travel range without binding.

Notes

* **Impact Limitations:** The TG9e is less robust and durable than the HXT900. It is susceptible to damage from sharp impacts or excessive physical strain. Always inspect the gears after hard landings or crashes.

* **Stall and Jamming Risk:** Ensure control surfaces are never blocked or bound. Physical resistance will cause maximum current draw, leading to rapid heat buildup and internal gear strip or electrical burnout.

* **Analog Driving Protocol:** Designed strictly for standard analog parameters (50 Hz to 60 Hz PWM refresh rate). High-frequency digital protocols will damage the internal control board.

Package

* 1 x Turnigy TG9e 9g Eco Micro Analog Servo

* 1 x 260 mm Integrated Universal Connection Cable

* 1 x Multi-Profile Nylon Servo Horn Selection Kit

* 1 x Mounting Hardware Fastener Pack