Flight Controller BETAFPV Aquila16 Brushless FC V1 AIO

This is a highly integrated board specially designed for the Aquila16 drone kit. Unlike standard self-assembled controllers, this model is optimized for stability, long flight (up to 8 minutes) and support for proprietary BetaFPV features for beginners.

Specifications

This controller integrates the processor, speed controllers (ESC), receiver and video transmitter control system.

Processor (MCU): STM32F411 (efficient chip for sustainable flight).

Sensors (gyros): BMI270 (via SPI).

Barometer: Built-in (allows the drone to maintain altitude, which is critical for N (Normal) mode for beginners).

Regulators (ESC): 1S 12A (supports Dshot300/600 protocols).

Built-in receiver: Serial ELRS 2.4G V3.0 (provides long range and stable communication).

Motor connectors: Pin 1.25 mm (quick connection without soldering).

Port for setup: Via a special 4-pin adapter (for connecting to a PC).

Power connector: BT2.0 (proprietary BetaFPV low impedance connector).

Firmware: Aquila16 V1.0 (optimized for working with BetaFPV Configurator).

Flight controller Aquila16 V1.0 AIO - 1 pc.

4-pin adapter cable (for connecting the board to a USB adapter).

Type-C to FC adapter (allows you to connect the drone to a computer for configuration in BetaFPV Configurator).

Set of dampers (anti-vibration rubber bands) – 4 pcs.

Screws for fixing to frame.

Power wire with BT2.0 connector (already soldered).