Flywoo GOKU F722 Pro V2 55A 32Bit 128K 30X30 Stack Plug&Play O4 / O4 Pro

The Flywoo GOKU F722 Pro V2 55A Stack is a high-performance power and control system engineered for premium racing, freestyle, and cinematic FPV drones. Driven by a high-speed STM32F722 processor clocked at 216MHz, this stack delivers lightning-fast processing speeds alongside a high-precision ICM42688 gyroscope. It pairs seamlessly with the GOKU G55M BLHeli_32 50A/55A ESC, utilizing an immersion gold PCB layout to guarantee superior thermal dissipation and structural endurance under heavy current loads.

Designed with extensive peripheral expansion in mind, the flight controller features dual ESC sockets to natively support up to 8 motor outputs—making it an exceptional platform for heavy-lift hexacopters and octacopters. It also includes modern snap-lock connectors alongside traditional solder pads, offering clean plug-and-play integration with the DJI O3 Air Unit.

Features

High-Tier Processing Core: Driven by an STM32F722 MCU running at 216MHz for ultra-low loop times and maximum peripheral multitasking capability.

Octacopter Expansion Ready: Features dual ESC harness connectors to support up to 8 motor outputs natively, perfect for multi-rotor cinematic builds.

Premium PCB Engineering: Built with immersion gold technology to heavily minimize resistance, manage heat distribution, and sustain high current bursts.

Solderless Snap-Lock Layout: Outfitted with plug-and-play wiring ports for effortless integration with the DJI O3 Air Unit, GPS modules, and receivers.

Pro-Tier ESC Performance: Uses full BLHeli_32 architecture with support for high-frequency PWM ranges from 24kHz to 128kHz for maximum motor efficiency.

GOKU F722 Pro V2 Flight Controller Specifications

MCU: STM32F722 (216MHz core)

IMU: ICM42688 (SPI)

Barometer: DP310

Blackbox: 16MB onboard Flash Memory

OSD: Betaflight OSD with AT7456E chip

UART Ports: 6 hardware sets (UART1 - UART6)

BEC Output: 5V@3A and 10V@3A dual independent high-power outputs

Input Voltage: 2–6S LiPo (7.4V – 26V)

Dimensions: 37×37×8 mm

Mounting Pattern: 30.5×30.5 mm (M3 holes)

Weight: 9.9 g

GOKU G55M BLHeli_32 4-in-1 ESC Specifications

Model: GOKU G55M BLHeli_32

Continuous Current: 55A

Burst Current: 60A (for up to 10 seconds)

Input Voltage: 3–6S LiPo

PWM Frequency Range: 24kHz – 128kHz

Protocols Supported: Dshot300 / Dshot600 / Dshot1200

Firmware Target: GOKU_F4A32_PRO

Weight: 15 g

Package Contents

1 x GOKU F722 Pro V2 Flight Controller board

1 x GOKU G55M BLHeli_32 4-in-1 ESC board

1 x Flight Controller-to-ESC interconnect harness

1 x DJI O3 Air Unit connection cable

1 x Analog VTX adapter cable

1 x FPV Camera connection cable

1 x GPS module connection cable

1 x Serial Radio Receiver cable

1 x External Buzzer adapter cable

4 x M3 Silicone vibration-damping grommet balls

7 x M3 Rubber spacer O-rings