The 5g Micro Analog Servo is a highly popular, ultra-lightweight actuator platform recognized by RC modelers for its exceptional price-to-performance ratio. Explicitly engineered for small-scale aircraft, micro indoor flyers, and space-constrained electronics projects, this module packs a 0.8 kg/cm torque output into a tiny 5-gram framework. Outfitted with low-friction Teflon bushings and an optimized micro motor core, it delivers responsive 0.10s transit speeds across a versatile DC 3.0V to 6.0V operating window, serving as a reliable and economical choice for weight-critical models.
Features
* **Ultra-Lightweight 5g Footprint:** Minimizes mechanical bulk and deadweight, protecting flight balance on micro park-flyers and indoor foamies.
* **Low-Friction Teflon Bushings:** Equipped with premium internal Teflon sleeves to reduce mechanical wear, smoothing out rotational travel without adding extra component mass.
* **Specialized Core Motor:** Features a custom-wound micro motor core engineered for stable current draw and reliable torque delivery in space-constrained casings.
* **Wide-Range Temperature Endurance:** Operates consistently across a harsh -30°C to +60°C environment corridor, preventing centering drift or component binding during seasonal outdoor flights.
Specifications
* **Brand:** Standard RC Component Architecture
* **Model:** 5g Micro Analog Servo Module
* **Dimensions:** 22.9 mm × 11.4 mm × 22.0 mm
* **Net Weight:** 5.0 g
* **Internal Gear Bushing Type:** Low-Friction Teflon Sleeves
* **Operating Temperature Corridor:** -30°C to +60°C
* **Primary Lead Wire Length:** 150 mm High-Flexibility Ribbon
* **Stall Torque Output:** 0.8 kg/cm
* **Speed:** 0.10 sec / 60° (@ 4.8V)
* **Voltage Range:** DC 3.0V – 6.0V Wide-Range Input Rail
Operational Instructions
1. **Mounting:** Fit the micro servo into its designated mounting slot or frame cutout. Secure the casing tabs using the included hardware screws without warping the plastic shell.
2. **Centering:** Power the system and apply a neutral PWM signal (1500µs) to home the output shaft splines before installing the control horn.
3. **Wiring:** Plug the 3-pin universal connector block directly into your receiver or flight controller PWM output rail, checking for correct pin alignment (GND, VCC, Signal).
4. **Pre-Flight Validation:** Run a manual sweep test to verify that all connected linkages, control hinges, or lightweight mechanisms move freely across their full travel limits without physical obstruction.
Notes
* **Light Payload Bounds:** This 5-gram actuator is strictly optimized for low-load micro models. Avoid deploying this servo on large control surfaces, heavy high-velocity aircraft, or mechanical linkages exposed to high external forces, which can instantly strip the micro gears.
* **Stall and Jamming Prevention:** Ensure control surfaces move fluidly and never bind. Physical blockages trigger maximum current draw, causing rapid localized heat build-up, gear deformation, and electrical chip burnout.
* **Analog Driving Protocol:** Designed strictly for standard analog parameters (50 Hz to 60 Hz PWM refresh rate). High-frequency digital servo protocols will over-cycle the internal H-bridge and quickly destroy the control board.
Package
* 1 x 5g Micro Analog Servo Unit
* 1 x 150 mm Integrated Universal Three-Wire Connection Cable
* 1 x Multi-Profile Nylon Servo Horn Selection Kit
* 1 x Mounting Hardware Fastener Pack
