BetaFPV F4 Brushed Flight Controller (DSMX Rx + OSD)

The F4 DSMX Brushed FC board from BETAFPV is a big step up from the F3 DSMX Brushed FC.

With an STM32F411CEU6 processor and a maximum current of 30A across all FETs, the F4 DSMX Brushed FC gives the drone a noticeable improvement in performance and power.

Specifications

PROCESSOR: STM32F411CEU6

Six axis: MPU6000

ESC: All FETs are rated at 30A maximum. Support 6x15mm/7x20mm/8x20mm/8.5x20mm etc. motors.

Size: 26mm x 26mm, fully compatible with Inductrix quadcopter frame and mounting pattern

Firmware version: Betaflight MATEKF411 3.5.0

OSD: Built-in BetaFlight OSD (STM32 drives OSD chip via SPI in DMA mode)

Receiver: DSM2/DSMX

Power cable: 55 mm, with JST-PH 2.0 connector, also known as PowerWhoop connector

Weight: 3.8 g

Kit

1 * F4 OSD matte flight controller DSMX Rx version (55mm PH-JST 2.0 power cable soldered)

4 * M1.2x4mm screws (Suitable for stock Inductrix frame)

4 * M1.4x5mm screws (Suitable for Beta75 etc. 75mm frame)

4 * Anti-vibration dampers

1 * 55mm PH-JST 1.25 pigtail power cable