Receiver iFligh ExpressLRS ELRS Nano Receiver RX 915Mhz

It's finally here - iFlight ELRS System! Extreme range and highest packet rate on the market for lowest latency. Signal loss is a thing of the past.

The ExpressLRS RX Nano modules have been developed in close collaboration with the ExpressLRS team, and the firmware is already available.

ExpressLRS official website: https://www.expresslrs.org/

Official ExpressLRS Quick Start: https://www.expresslrs.org/2.0/quick-start/getting-started/

It is an open source project available to everyone for free. If you would like to support the developers, please consider donating: https://opencollective.com/expresslrs

Features

Improved circuit

Updated temperature-compensated crystal oscillator (reduced packet loss, high frequency stability)

High performance at 2400 MHz or 900 MHz (900/868 MHz bands available)

Performance and Compatibility

Install the antenna away from leading or magnetic elements (carbon, metal, motors).

Update your firmware to the latest version and follow the ELRS Community for updates, instructions, or development contributions.

Use iFlight ELRS receivers with iFlight transmitters for maximum performance. They have one of the best frequency stability on the market.

Frequency options

The 900MHz and 2400MHz bands provide excellent performance and range. If you're unsure about your choice, check out the official ELRS Long Range tests.

Due to local regulations, the 900MHz band in the FCC region shows better performance than the 868MHz band in the EU. The 2400MHz frequency is suitable for any region and has a higher refresh rate (up to 500Hz). This is not a normal 2.4GHz protocol and cannot be compared with other analogues on the market.

Characteristics

Antenna Connector: IPEX(868MHz/900MHz/2.4GHz)/SMD Antenna(2.4GHz with SMD Antenna)

Firmware: ExpressLRS iFlight 900MHz Nano RX(868MHz/900MHz) / ExpressLRS iFlight 2.4GHz Nano RX(2.4GHz)

Frequency bands: 868MHz EU/900MHz FCC/2.4GHz ISM

Telemetry power: 17dBm (50mW 868/900MHz)/12.3dBm (17mW 2.4GHz)

Dimensions: 10×13mm

Connector: SUR0.8

Interface: RX TX 5V GND

Input voltage: 5V

Protocol: CRSF

Weight: 0.5g

Equipment

1 × ExpressLRS Nano receiver

1 × Antenna 70mm