Video transmitter iFlight BLITZ Whoop 5.8GHz 1.6W VTX

The iFlight BLITZ Whoop 5.8GHz 1.6W VTX is a high-power analog video transmitter engineered for tight multirotor builds, micro long-range setups, and freestyle FPV platforms. Delivering 5 adjustable power stages up to a high-penetration 1600mW output ceiling, it guarantees exceptional signal propagation and robust link stability across expansive operating boundaries. Built with a minimalist, space-saving layout optimized for the standard micro-sized 25.5×25.5mm mounting pattern, it integrates seamlessly into whoop and toothpick frames while weighing only 6.5 grams. Outfitted with an active over-temperature protection system and a wide 7V to 26V voltage tolerance, it natively supports Betaflight VTX table configurations via the standardized IRC Tramp telemetry protocol for effortless remote parameter tuning.

Features

High-Output Power Scaling: Outfitted with adjustable power steps capable of stepping from stealth PIT mode up to a powerful 1600mW (1.6W) maximum output, making it ideal for deep-range aircraft tracking.

Micro Whoop Mounting Core: Highly unique structural design fits a standard micro-sized 25.5×25.5mm mounting pattern, allowing ultra-high-power 5.8GHz deployment inside lightweight whoops and toothpick frames.

IRC Tramp Telemetry Interface: Seamlessly integrates with standard IRC Tramp protocol fields, allowing pilots to modify video channels, bands, and power steps directly through the Betaflight OSD.

Intelligent Over-Heat Safety: Built-in temperature control monitoring actively safeguards internal processing circuits by throttling RF output stages if thermal safety thresholds are crossed to prevent component damage.

Expansive Frequency Spectrum: Operates across a comprehensive 40-channel matrix spread evenly over 5 frequency bands, fully incorporating a highly stable Raceband corridor to minimize inter-pilot signal washing.

Broad Voltage Compatibility Matrix: Supports a wide input voltage corridor from 7V to 26V DC, enabling hassle-free direct power integration straight from 2S to 6S LiPo battery mainlines.

Specifications

Brand / Model: iFlight BLITZ Whoop 5.8GHz 1.6W VTX

RF Carrier Frequency: 5.8 GHz Spectrum Core

Available Channel Matrix: 40 Selectable Channels (including Raceband)

RF Output Power Platform: PIT / 25 mW / 400 mW / 800 mW / 1600 mW (Adjustable)

Telemetry Integration Bus: IRC Tramp Protocol (Betaflight VTX Table Compatible)

Primary Operating Input Voltage: 7.0 V – 26.0 V DC (Supports direct 2S – 6S LiPo mainlines)

Antenna Interface Connector: Low-Loss Miniature U.FL (IPEX) Base

Mechanical Mounting Pattern: 25.5 mm × 25.5 mm Stack Alignment

Weight Parameter: 6.5 g (excluding external antenna element)

Notes

Factory Default Power Step: For safety and regulatory compliance, the VTX is pre-configured out of the box to a standard 25mW output ceiling. High-power settings must be manually unlocked via the firmware configuration.

Before use install the antenna. Running a high-power VTX without an antenna will cause instant, catastrophic damage to the RF amplifier stage.

Fly with constant airflow and in a well-ventilated environment to prevent overheating. Operating transmission profiles above 25mW may require specific operator licensing or local regulatory approval depending on your region.

Package

1 x iFlight BLITZ Whoop 5.8GHz 1.6W VTX Module

1 x Dedicated Hardware Wiring Harness Set